Reproduction All Tiled Fireplaces
Click here to return to Reproduction All Tiled Fireplaces sub-menu

Click pictures below to enlarge

The Wyndham All Tiled Fireplace

ra01

An Art Deco Fireplace design with the detail
faithfully copied from an original tiled Fireplace
back-panel dating from the 1920s/30s.

It was originally made to go inside a wooden
Fireplace Manteland is available as a tiled insert but
we have found that this design is also very
effective as an All Tiled Fireplace.

These Fireplaces are shown at 40" wide but
can be manufactured at any size and with
variations in shape if necessary. We offer
a complete bespoke service where each Fireplace
is manufactured to a customers requirements.

Tiled Fireplace including hearth and fret from

£875

To burn solid fuel a stool grate is also required.
Living Flame Gas Fires are also available
to suit these Fireplaces.

All Tiled Fireplace products are manufactured in
Manchester at our factory/showroom site

Different opening tiles are available in different designs.

Hearth sizes
Originally most pre-war Fireplaces would have had
hearths laid flush with the wooden floor. In general
they were about 48" wide and 18" deep.
Current gas and solid fuel regulations now stipulate
that a 2"(50mm) raised hearth is required.

Our hearths can me made in large sizes so that
the Fireplace Mantel stands on it, small so that the Fireplace Mantel
stands on the floor or somewhere in between
(either the Fireplace Mantel or the hearth is cut out).
The standard sizes are small (39.5" x 16"in 4" tiles)
and large( 54"x15") in 6" tiles but they can be made
in any size or shape on request.

Our Tiled Fireplaces can be made in many sizes and colours.
The main colours we use are now shown on our tile colour page

20th Century Fires reserves the right to make minor design changes to the reproduction inserts or Fireplace Mantels shown on this site.

Our tiles are reproduced using similar methods to the original items and the degree of shade variation is inherent and desirable. Tiles are manufactured to bs6431 and are not guaranteed against crazing. Whilest most tiles do not normally craze, the thickness of glaze necessary to reproduce the very shiny Victorian colours may occasionally cause this to occur. It does not affect the serviceability and actually achieves a truer degree of reproduction effect. In certain conditions high gloss glazes are prone to discolouration and marking due to chemical attack from certain liquids including hard water. Victorian colours are easily scratched and should not be used in areas subject to abrasion.